If you subscribe to the Caller ID service, the printer detects the sender's Caller ID.
If you select ON, the printer rejects the reception of faxes with no sender information or faxes from specific senders. If you select Enable, you can use the on hook dial function. If it matches the number, the printer starts to send faxes. If you select ON, the printer checks whether the recipient's fax device information matches the dialed number. By using this setting, you can avoid the mistransmission of faxes. If you select ON, you can set the printer to send faxes after entering the number twice. However, part or all of the fax may not be printed since the ink has run out. Sets whether to continue printing the received fax without storing it in the printer's memory when the ink has run out. If you print RX REPORT, select Print error only or Print for each RX. Selects whether to print RX REPORT automatically after receiving a fax. If you select Print error only or Print for each TX, you can specify the print setting that the first page of the fax is printed along with the report. If you print the report, select Print error only or Print for each TX. Selects whether to print TX REPORT/ ERROR TX REPORT automatically after sending a fax. If you select Print, the printer prints ACTIVITY REPORT for the 20 histories of sent and received faxes automatically.įor details on the procedure to print ACTIVITY REPORT manually: Selects whether to print ACTIVITY REPORT automatically. If you select Do not print, the received fax is stored in the printer's memory.įor details on the received fax stored in the printer's memory: Selects whether to print the received fax automatically when receiving a fax. When the telephone line condition or connection is poor, selecting a lower reception start speed may solve reception problems.
The fax reception start speed will be faster as the value is bigger. When the telephone line condition or connection is poor, selecting a lower transmission start speed may solve transmission problems. The fax transmission start speed will be faster as the value is bigger.
Selects whether to receive faxes in Error Correction Mode (ECM). Transmission/Reception of Faxes Using ECM.Selects whether to send faxes in Error Correction Mode (ECM). If you select ON, you can select the image reduction direction. If you select Disconnect, the printer does not send color documents when the recipient's fax device does not support color faxing.Įnables/disables automatic reduction of incoming faxes so that they fit in the selected paper. When faxing color documents using the ADF, selects whether to convert them into black & white data if the recipient's fax device does not support color faxing. If you select ON, you can specify the remote reception ID. Selects the position of the sender information (outside or inside the image area). Sets the length of pause time for each when you enter "P" (pause). This setting may not be available depending on the country or region of purchase.If you select ON, the printer transmits the fax after confirming the dial tone. If you select ON, you can specify the maximum number of redial attempts and the length of time the printer waits between redial attempts.Īvoids mistransmission when reception and transmission occur at the same time. This setting has priority even if you select 33600 bps for TX start speed or RX start speed.Communication time generally becomes longer than when communicating with V.34 (super G3). When Reduce is selected, V.34 (Super G3) can not be used.If you select Reduce, it may be possible to reduce the incidence of communication errors when connecting to internet line such as IP phone.